ULTRAFILMCUTversusFilmCut
A budget subscription sold through tint and plotter retailers, marketed on a very large combined tint and PPF pattern count.
FilmCut details are compiled from publicly available information and were last verified August 2026.
Bars illustrate the shape of the difference, not a score.
- Free cutting access with UPPF film roll numbers, which drops software cost to zero for film buyers
- In house pattern design team with a two to four week custom request turnaround
- Direct manufacturer support rather than a reseller in the middle
Pick ULTRAFILMCUT if
You buy film in volume and would rather have the software included with it.
- Low published price with no long term contract
- Mac support, which most PPF pattern software still lacks
- You can browse the catalog before paying
Pick FilmCut if
You run a Mac based shop and a low flat monthly rate is the deciding factor.
What moving actually involves
- 01
Run both for two weeks
Start the trial while your current subscription is still live. Cut the same vehicles you cut last week and compare fit on the car, not on a spec sheet.
- 02
Keep your plotter
No hardware change unless your current software is bundled to a machine. Re run the calibration square and note your numbers.
- 03
Check your real vehicle list
Pull the last thirty jobs from your calendar and search each one. Coverage of your actual mix matters more than any total pattern count.
- 04
Decide on the car
The only test that counts is edge quality on a real install. If it is not better or cheaper, stay where you are.
Other comparisons
XPEL DAP
Roughly $200 per month and up
CORE
Commonly quoted around $400 per month at the top tier
3M Pattern Marketplace
Commonly quoted around $180 per month
DigiCut
Distributor dependent
AeonCut
Commonly quoted near $179 per month
YINK
Bundled with hardware
Or read the ranked guide: best PPF cutting software in 2026.
ULTRAFILMCUT vs FilmCut questions
You buy film in volume and would rather have the software included with it. If the opposite is true for your shop, FilmCut is the better buy and this page says so.
Commonly listed at $99 per month. Sold through retail partners such as plotter and tint suppliers. Compiled from publicly available information, last verified August 2026.
Only if your current setup came bundled with proprietary hardware. ULTRAFILMCUT drives Graphtec, Roland, Summa, Mimaki and USCutter machines directly, so most shops keep the machine they own.
Yes, and it is the sensible way to decide. Run the 14 day trial on your own plotter, cut the same vehicles you cut last week, and compare fit rather than feature lists.
Cut a real pattern before you pay for anything
Request a trial code, install on your Windows workstation, and cut on the plotter you already own. Fourteen days, no card.